Skip to content

How To Configure EIGRP With Different Area In Cisco Packet tracer

Our Score
Click to rate this post!
[Total: 0 Average: 0]

In This Tutorial We Are Going To Learn How To Configure EIGRP Using Different Area In Cisco Packet Tracer 

It Is Very Easy To Configure EIGRP Using Different Area If You Want To Configure By Yourself Then You Have To Follow Just These 2 Simple Steps

Advertisements

Here Is The Diagram You Can Check First

 

Step-1 Firstly You Have To Assign The Ip To All The Routers And The Pc’s

After Assining The IP Addresses To All The Routers And The Pc’s Now You Have To do The Routing Of EIGRP Using Different Area

Step-2 Here Is The Command Of Configure EIGRP Using Different Area

Command To Run In Router 1

router>en
router#configure terminal
router(config)#router ospf 1
router(config-router)#network 1.0.0.0 255.255.255.0 area 1
router(config-router)#network 2.0.0.0 255.255.255.0 area 1
router(config-router)#exit
router(config)#exit
router#

Command To Run In Router 2

router>en
router#configure terminal
router(config)#router ospf 1
router(config-router)#network 3.0.0.0 255.255.255.0 area 2
router(config-router)#network 2.0.0.0 255.255.255.0 area 1
router(config-router)#exit
router(config)#exit
router#

Command To Run In Router 3

router>en
router#configure terminal
router(config)#router ospf 1
router(config-router)#network 4.0.0.0 255.255.255.0 area 2
router(config-router)#network 3.0.0.0 255.255.255.0 area 2
router(config-router)#exit
router(config)#exit
router#

This IS All The Configuration Of EIGRP Using Different Area

Leave a Reply

Discount Offer

Now Get 67% Discount

On Cyber Security Training                                                       Notes  

Click here  To Purchase

%d bloggers like this: